McCown Technology Corporation GigE POE APC Surge Suppressor

McCown Technology Corporation 800-GIGE-POE-APC

GbE PoE APC Surge Suppressor

This MTC GigE Ethernet surge suppressor -protector with midspan POE insert/extract. Configuration via jumper plugs allow any combination of polarity and pair use with up to 1.25 amps per pair. If all 8 wires are configured as the same polarity, 5 amps can be conveyed. This device will power 802.3af/at devices or extract power from a POE powered circuit. Shielded RJ45 jacks provide grounds to shielded plugs.

Features:

• GigE Ethernet surge suppression
• Shielded RJ45 connectors provide a ground to shielded plugs
• Ultra fast suppression – typically less than 1.0ps from 0 Volts to BV min
• Faster acting than Thyristor and Gas Tube only designs
• Bi-Directional TVS provides full protection even during a destructive surge
• Lower loss and crosstalk than Thyristor based designs
• Ethernet CRC error correction circuit
• Ultra fast suppression – typically less than 1.0ps from 0 Volts to BV min
• Up to 2.00 amp total (500mA per pair) POE capability (RJ45 limits are 500 mA or less per pair)
• Any polarity on any pair – total flexibility

Applications:

• Backhaul radios
• Point to point microwave radio powering
• Installed at outdoor tower colocation sites
• Conveying power over unused Cat5/6 cables
• Emergency spare POE
• Pulling power from POE circuits
• Powering Cameras
• Up to 68 volts AC or DC
• Note: Does not allow “split pair” powering for devices like Canopy PMP430