Tycon Power 12VDC 300W Wet/Gel Battery Charger
|Total Power Available (for Load and Battery charging)||300W|
|Nominal Battery Voltage||12VDC|
|Load Output Min Current||1A|
|Load Output Max Current||12A|
|Overdischarge Protection||10.7V Load off / 12.6V Load on|
|Battery Charge Max Current||12A|
|Battery Charger Voltage||WET Equalize = 14.6V, Float = 13.2V GEL Equalize = 14.2V, Float = 13.5V|
|Line Regulation / Ripple||1%|
Tycon Power TP-BC12-300
High Power Battery Charge Controller
The TP-BC series of smart battery chargers provide up to 300W of total power. Part of the power is allocated to the regulated load output and remaining power is allocated to battery charging. The smart battery charger is compatible with GEL/AGM type sealed lead acid batteries and also WET type lead acid batteries (like car batteries).
The load output is regulated so that output voltage does not exceed 12.5VDC on the 12V model and 24.5VDC on the 24V model and 48.5VDC on the 48V model. Also the load output will turn off when the battery voltage is low to prevent over discharge of the batteries which can shorten the useable life of the batteries. Load output will turn back on automatically when batteries have sufficient charge. The TP-BC series provides seamless switchover from AC power to battery power so there is no interruption which could reset a user’s electronics. The charger auto-recovers from a power failure so no user action is necessary.
The charger has various protections for short circuit, overvoltage protection, overcurrent and reverse battery. It operates over a wide temperature range making it suitable for industrial applications.
The battery charger will not work without a battery connected.
A solar panel and solar charge controller can be added to the system if supplemental power from solar is desired. A Wind Turbine can be added if wind power is available.
There are various LEDS on the front panel to see status-at-a-glance of the Load Output, Charging Condition and AC Power Condition.