Tycon Power UPSPro 192W 2400VA 24VDC
|Load Voltage||24V +/- 0.5V|
|Maximum Load Output||8A (192W)|
|Minimum Load Output||1A|
|Available Storage Capacities||2 battery 51Ah 1200VA |
4 battery 102Ah 2400VA
|Battery Type||Non-Spillable Valve Regulated Sealed Lead Acid / GEL|
|Battery Life (Typical)||5 Years|
|Charge Voltage||WET Equalize = 28.8V |
Float = 26.4V GEL Equalize = 28.4
|Maximum Charge Current||12A|
|Over-discharge protection||21.5V Load Off|
25.2V Load On
|Other Protection||Short Circuit, Reverse Battery, Over Voltage|
|VAC Input +/- 10%||Selector Switch 120VAC / 240VAC , 50/60Hz|
|VAC Input Current||3.5A @ 115VAC / 1.8A @ 240VAC|
|Enclosure External Size||24 x 15 x 14" (610 x 381 x 356mm)|
|Enclosure Internal Size||23 x 14 x 12" (584 x 356 x 305mm)|
Tycon Power UPS-ST24-100Enclosure Type: Steel
Battery Voltage: 24VDC
POE Output Voltage: N/A
Battery Capacity: 102Ah
The UPSPro™ ST outdoor UPS systems are designed to provide up to 192W backup power. There is enough backup power to keep a wireless base station alive for many hours. The controller provides load control to make sure the batteries don’t over-discharge. This greatly extends the life of the batteries. The load output is also regulated to be sure that the voltage doesn’t exceed the maximum voltage allowed by the load. The system is powered from 120VAC or 240VAC power. In case of power failure the transition to battery power is seamless and automatic. Recovery is automatic. The controller supports GEL/AGM or wet batteries. Systems are available without batteries to save on international shipping costs.
The weatherproof enclosure with security locks has multiple ports for CAT5 cable, solar and other cabling. It is vented to prevent residual buildup of any hydrogen gas. The included bracket kit allows for the enclosure to be pole mounted or wall mounted. The systems are rated to operate over a wide temperature range of -30C to +60C.
There are multiple system configurations available: 12V 51Ah(600VA), 12V 102Ah(1200VA), 12V 204Ah(2400VA), 24V 51Ah(1200VA), 24V 102Ah(2400VA) and 48V 51Ah(2400VA) Battery.
There is a generous amount of space reserved inside the enclosures for customer electronics such as controllers, wireless AP or CPE cards, sensors, inverters, etc. The standard component layout is designed for ease of maintenance.
Equipment runs on battery power which isolates it from power line surges which is a main cause of outdoor equipment failure.
The system is also compatible with the TPSK Solar panel kits. A TPW wind turbine system can also be used as an alternate power source in addition to solar and AC power.